26.01.2018, 13:14
(26.01.2018, 12:45)Andre schrieb: Ok, just want to be sure that the app works fine.When I tap the "DSP" button on the I-Bus app it say something like "source set to Tuner." I can't read the DSP with IPNA or any other tool while the Avin unit is hooked up.
Well, we would check this via multimeter.
Another option: read out the dsp via I**A, look at status if a source is set (Tuner) or will be set it you tap on "Tuner" in DSP-Mode of the app.
Also you see there, if it's on or not, etc.
And you may check there, if the DSP act like you change values in the app.
I have the older style 17 pin connector and I understand that pin 16 "ANT out" should be carrying 12V. I'll try to see if I can confirm that with a multimeter.